Replacing DC motor with AC motor and AC VFD

/in /by

Customers of Precision Electric who operate DC drives and motors often inquire about replacing and upgrading their DC equipment with AC equipment. To help users faced with this dilemma, I have decided to post about the topic.

Of course, the main advantages of DC drives are that they cost less, produce less heat, have smaller footprints and are easier to fix in the field. They also can perform high torque at low speed and handle high-impact loads. However, the main knocks against DC drives are that the motor costs more and requires some maintenance, and they need a field supply, which adds complexity.

DC drive systems also require accessory equipment, such as inductors, contactors and fusing, and many users are increasingly unfamiliar with DC technology.

Meanwhile, the advantages of AC drives are that they’re used with AC induction motors, so there are no brushes to maintain, and the price of an AC drive system, including the motor, is more cost-effective than a DC drive. AC drives also have better power factors, are easy to install and start up, are available from multiple vendors and can run motors efficiently across the whole speed range.

However, the disadvantage of AC is that the drive is fundamentally more complex, involving volts and amps and hertz. Also, line regeneration is possible, but expensive, and brake choppers are sometimes necessary, but they waste energy and give off heat.

Despite these many differences, there are some areas where DC and AC drives come to a tie. They also have comparable drive features, ease of commissioning when looking at state-of-the-art DC drives, as well as reliability and maintenance of the drive.

Precision Electric recommends that users replace their existing equipment with an AC system when:

  • The existing DC motor is near its end of life,
  • Power factor and distortion are an issue, such as when the DC motor has a poor power factor when running below base speed, or when you’re paying a penalty or need to add a power factor correction, or when there’s an IEEE 519 requirement;
  • The motor is small, perhaps less than 200 hp, so the money difference becomes insignificant given the many benefits that will be gained with an AC system; and
  • The machine can be out of service for a longer period of time.

Users should upgrade their DC drives when:

  • You want to save money, as when the DC drive replacement costs less than AC system replacement throughout the HP range;
  • The existing DC motor is in decent shape, and spares are readily available;
  • Your situation requires fast upgrade with minimal downtime.

Users also should consider a DC drive or system replacement for large motors, especially above 1,000 hp or above 690 volts; if they have a large regenerative load; or if their DC motor is not easily replaceable with an AC motor. This may be because of differing shaft height and shaft diameter, difficult position or hard-to-reach components, or if they their application has special cooling needs.

If you are considering replacing your DC equipment with AC equipment and are unsure about your decision, call or email us. Precision Electric has been serving the industrial manufacturing world for over 25 years and has over 100 years of combined experience in the field.

Ryan Chamberlin
Inside Sales, Customer Support
[email protected]